Planet Bike Protegé Supporto per computer da bici con ruota posteriore (cavo da 130 cm e hardware)

Brand:Planet Bike

3.1/5

44.44

Compatibile con Protégé 5.0, 8.0 e 9.0. Include magnete per ruota (adatto per raggi a lama fino a 4 mm) e fascette. Filo da 130 cm. Si adatta alla maggior parte delle barre (da 25,4 a 31,8 mm). Ideale per i trainer per biciclette indoor con ruota posteriore. Compatibile con: Protegé 5.0, 8.0 e 9.0. La staffa si adatta alla maggior parte delle barre (da 25,4 a 31,8 mm). Contiene staffa con cavo da 130 cm, magnete ruota (adatto per raggi a lama fino a 4 mm) e fascette.

Compatibile con Protégé 5.0, 8.0 e 9.0. Include magnete per ruota (adatto per raggi a lama fino a 4 mm) e fascette. Filo da 130 cm. Si adatta alla maggior parte delle barre (da 25,4 a 31,8 mm). Ideale per i trainer per biciclette indoor con ruota posteriore. Compatibile con: Protegé 5.0, 8.0 e 9.0. La staffa si adatta alla maggior parte delle barre (da 25,4 a 31,8 mm). Contiene staffa con cavo da 130 cm, magnete ruota (adatto per raggi a lama fino a 4 mm) e fascette.
Brand Planet Bike
Color Black
Material plastic

3.1

8 Review
5 Star
59
4 Star
13
3 Star
10
2 Star
6
1 Star
12

Scrivi la tua recensione

La tua mail non sarà pubblicata. Tutti i campi obbligatori sono segnati con*

Scritto da: RJM
Challenging to mount
Challenging to mount. I wanted a rear wheel mount to use on a bike on a trainer. The rear is the only wheel spinning. The cable uses a sensor that is mounted on the seat stays. Then a magnet is attached to a rear wheel spoke. The distance between the sensor and the magnet needs to be 2-5 mm. On my bike with a derailleur the distance between the spokes and seat stay is huge. Planet Bike support suggested a shim. It needs to be a big shim. I used a piece of pool noodle and some felt furniture slider. It worked! The spoke magnet and sensor are now about 5mm apart. I use this with a Protege' 5.0 computer. I now have speed, distance and time for my workouts.
Scritto da: RB SF
Great For Stationary Trainer
Love it! Works as advertised. I installed the mounting end on the handlebars & wrapped my way to the rear wheel. The cord it not extremely long, but adequate. My husband had another computer on his bike, and hated it. He was the only one cycling for quite a while. I finally got jealous of his weight loss & fitness and purchased a trainer for my (under used) road bike & the Protege 8. Once I got the Protege 8 all set up with this cable installed, there were no issues. I have now “ridden” over 400 miles with no issues. A few weeks ago hubby upgraded to Protege 8 too (with another one of these kits). We’re both happy.
Scritto da: ykceralde
Difficult to properly install
I bought this because the computer I bought only came with a front wheel mount for the sensor and I was going to be using a trainer indoors for a couple of months, so I needed the sensor to be on the back wheel. The sensor works perfectly but they don't account for how much further away the rear part of the bike frame is from the actual wheel. With a 2mm tolerance it is impossible to get the sensor and magnet close enough together without using about an inch of rubber. Once you get it installed it's great, but beware of this flaw and plan ahead.
Scritto da: Gregory Semerdjian
Easy to install
I wanted something that would attach to the rear wheel. This product is perfect. Easy to install and the wire is long enough for a perfect fit.
Scritto da: Cavebiker
Installed on recumbent
I installed the holding bracket on the front fork of a short wheelbase recumbent, using the 130 mm length version. The cord is long enough, with several mm's to spare. Installation was simple and easy, but from the spacing required, it was apparent that installation on a rear wheel would have required the addition of spacers to bring the sensor close enough to the magnet. Directions were clear and it is easy since the installation can be on either the right or left side fork.
Scritto da: Stumpy
I was pleased with the product
Worked as advertised. I was pleased with the product
Scritto da: Larry harvey
The cord in no way reaches the back wheel. Do not buy this.
The cord was way too short. Sending it back!
Scritto da: J.Hayes
Need a Rear Wheel Sensor. buy this..
This worked!! was trying to find a sensor for the rear wheel of my bike( in a stand ) and this worked once it was connected to the display.

Prodotti correlati

Scopri il nostro network internazionale

Spediamo in 28 paesi, oltre 200.000 prodotti. Resta aggiornato, iscriviti alla newsletter.

Shopping Cart